Step 2 step 3 – ParkZone PKZ4175 User Manual
Page 3
3
T
T
A
B
•
O
R
H
T
•
V
EL
E
•
)
R(
EL
I
A
•
)L
(
EL
I
A
•
D
D
U
R
•
1
X
U
A
•
T
T
A
B
•
O
R
H
T
•
V
EL
E
•
)
R(
EL
I
A
•
)L
(
EL
I
A
•
D
D
U
R
•
1
X
U
A
•
Wing Tab
Wing Tab
Step 2
Step 3
Installing Landing Gear
1. Slightly squeeze together the legs of the landing
gear while sliding it into the allotted space on the
fuselage undercarriage.
2. The fit should be snug, so it will not easily pull out.
3. Gently tug on the landing gear to ensure that it is
inserted all the way into the fuselage and will not
come out when the plane is in use.
Attaching the Wing
1. Locate the wing set. Note that the servos are
located in the bottom of the wing.
2. Select a wing half and slide in fuse, making sure
that you slide aileron servo lead in first (in allotted
hole in side of fuse). Pull aileron lead carefully through
fuse in order to allow wing tab and spar to go into
their allotted holes. Do the same with the other
wing half.
3. Carefully slide wing halves toward each other until
the wing tabs overlap.
4. Match up the holes on each tab and secure with
included screw.
5. Plug in the aileron connectors into receiver. Left
aileron should plug into allotted space of receiver
(directly below elevator). Right aileron lead should
plug into second space of Rx allotted for aileron.
6. Attach the clevis of the aileron linkage to the
bottom (outermost) hole of the aileron horn.
Once you gain more experience, you can insert the
clevis into holes on the aileron horn that are higher
in order to do more extreme maneuvers with
your Typhoon 3D PNP.
Always check ailerons prior to flight to make sure they
are not reversed! Trim adjustments to the ailerons
may be necessary prior to flight.