Dremel SM20 - Manual (Page 12)

DEPTH ADJUSTMENT
Disconnect plug from power source. Loosen
the depth adjustment lever located on the right
side of the tool. The foot is spring loaded and
will lower automatically (Fig. 5).
Tighten lever counter clockwise at the depth
setting desired. Check desired depth (Fig. 5).
DEPTH SCALE
DEPTH
ADJUSTMENT
LEVER
FIG. 5
-12-
FIG. 4
LINE GUIDE
The cutting guide notch will give an
approximate line of cut (Fig. 6). Make sample
cuts in scrap lumber to verify actual line of cut.
LINE GUIDE
FIG. 6
"LOCK-ON" BUTTON
The "Lock-ON" feature, incorporated into the
paddle switch, is a convenience for long
operations.
TO LOCK SWITCH "ON": After paddle switch
has been activated push "Lock-ON" button at
rear of tool completely in and release paddle
switch (Fig. 4).
TO SWITCH TOOL "OFF": Squeeze and
release paddle switch (Fig. 4).
In order to try to avoid recoil (a situation where
the wheel wants to skip out of the material) it
is recommended to make cuts in the same
direction as the rotation of the wheel.
It is important to read and
understand the section in
this manual called “Kickback and Related
Warnings”.
! WARNING
PADDLE SWITCH
"LOCK-ON"
BUTTON
"LOCK-OFF" SWITCH
RELEASE LEVER
DM 2610013190 06-11:DM 2610013190 06-11.qxp 6/6/11 10:43 AM Page 12