Paradigm Millenia CT Upgrade Kit User Manual

Page 3

4. The LED on the front of the Millenia CT 2’s Control Box will flash ‘BLUE’

5 times in quick succession to confirm the command was received.

5. Wait a few seconds, then again press the button on the 2nd remote

control to confirm the desired command.

6. The LED on the front of the Millenia CT 2’s Control Box will again flash

‘BLUE’ 5 times in quick succession to confirm the command was received.

7. If the command was learned correctly, the LED on the front of the

Millenia CT 2’s Control Box will now glow a brighter ‘BLUE’.

Repeat steps 2 through 6 to learn additional commands. NOTE: If you wait

more than 20 seconds between programming commands, the Millenia CT 2

will exit the IR Learning Mode. Then you will have to start the entire process

again in order to program additional features.

To end IR Learning

If no other command is pressed, the Millenia CT 2 will automatically exit

IR Learning Mode in 20 seconds.
What to do if the LED flashes ‘PURPLE’

If the LED on the front of the Millenia CT 2’s Control Box flashes ‘PURPLE’,

the command was not received correctly. Please try again. If the LED on the

Control Box flashes ‘PURPLE’ after a second attempt, the Millenia CT 2 may not

be able to learn your remote control.
IMPORTANT: The IR Learning Mode operates via standard 38Khz IR protocol

only. Not all remotes function in the same manner. If the LED on the Control

Box continues to flash ‘PURPLE’ it could indicate an error, please try another

remote control.