Paraclipse Mosquito Eliminato - Manual (Page 4)

Mounting Instructions
Save these instructions
Page 4
Paraclipse Mosquito Eliminator ™ Contents :
 Operation Manual.
 Anchor kit with Instructions.
 Two drywall anchors.
 Instructions.
 Screws.
 One Frame Assembly.
 One Cartridge.

One UV Lamp.
Unit location on wall - Fig. 1
Select a wall away from windows or competing
light source. For best results, install unit 4’ to
6’ (1.2 m to 1.8 m) above the floor.
Mounting unit to wall - Fig. 2
1. Mark two locations on the wall for your fasten-
ers that are 7” apart. Make sure that the
marks are perpendicular with each other. The
two wall mount keyholes are located on the
back of unit (Fig. 2).
2. Use a Phillips head screwdriver to mount the
frame assembly on the wall. The frame as-
sembly must be securely mounted to the
wall.
NOTE: For other surfaces, such as concrete,
different fasteners or anchors may be required.
These types of fasteners are not included.
.
4’-6’ (1.2m-1.8m) Preferred Height
Note: 6’ 6” (2.0m)
maximum height
Fig. 1
62670 04-15-14
Fig. 2
Keyholes
Paraclipse Mosquito Eliminator™
Page 5
Lamp Installation Procedures
To install a replacement lamp you must first remove access
door. To remove access door, with the door facing you,
grab the middle edge of the door, push towards back of
unit and pull towards you. (Fig.1) The door will come com-
pletely off the unit (Fig.2).
Remove the cartridge by gently pulling out of unit towards
you.
Remove Access Door
Remove Cartridge
Fig.3
Cartridge Body
Drive Spool
Supply Roll
Remove Old Lamp
Remove old lamp by pushing upwards and turning clockwise
on the base of the lamp (Fig.4).
Install New Lamp
Hold the cartridge body in your hand (Fig.3) with the drive
spool knob facing you. Slide the cartridge into place making
sure the drive spindle is engaged with the motor drive shaft
(located towards top of unit) and the supply roll placed on the
guide pin (located towards bottom of unit).
Install Cartridge
Install Access Door
To put the access door back on simply line up the four
tabs on the door with the back plate of the unit. Once
the tabs (Fig.2) are lined up push the front of the door
closed. The door will firmly snap into place.
Insert UV Lamp into socket and gently push up-
wards while turning lamp counter clockwise
approximately 1/8 turn until the (2) lamp pins
engage into the socket. Hold by the base of lamp
when installing.(Fig.4).
Fig.4
Base of Lamp
Access Door
Fig. 1
Access Door
Tabs
Fig. 2
Lamp
62670 04-15-14