Paraclipse Mosquito Eliminato - Manual (Page 3)

Save these instructions
Page 6
Cartridge Information:
The Paraclipse Mosquito Eliminator ™ is unique
in that the cartridge is automatic. After the initial
start-up, the cartridge will automatically advance.
Manual Paper Advance:
You can manually advance the tacky paper
surface by simply turning the drive spool
clockwise until the desired amount of tacky paper
is available to catch insects. (Fig. 3)
This is required when installing a new cartridge
and advancing the paper due to heavy insect
catch.
To install a replacement cartridge you must first remove access
door. To remove access door, with the door facing you, grab the
middle edge of the door, push towards back of unit and pull to-
wards you (Fig.1). The door will come completely off the unit (Fig.2).
Remove the cartridge by gently pulling out of unit towards you (Fig.4).
Remove Access Door
Remove old Cartridge
Hold the cartridge body in your hand (fig.3) with the drive spool
knob facing you. Slide the cartridge into place (Fig.4) making sure the
drive spindle is engaged with the motor drive shaft (located towards
top of unit) and the supply roll placed on the guide pin (located to-
wards bottom of unit). Once cartridge is in place rotate the drive
spool in the direction of the arrow shown until glue surface spans
the full length of the cartridge. This will require 7 to 8 rotations.
Install New Cartridge
Install Access Door
To put the access door back on simply line up the four
tabs (Fig.2) on the door with the back plate of the unit.
Once the tabs are lined up push the front of the door
closed. The door will firmly snap into place.
Fig.3
Access Door
Fig. 1
Drive Spool
Access Door
Tabs
Fig. 2
Cartridge Body
Access Door
Replacement Cartridge
Fig.4
REPLACEMENT CARTRIDGE PROCEDURES
62670 04-15-14
This symbol is intended to alert you of
the presence of dangerous voltage
within the unit’s enclosure that may be
of sufficient magnitude to constitute a
risk of electric shock. This symbol is intended to alert you
of the presence of important operat-
ing and maintenance instructions
accompanying the unit.
Caution! To reduce the risk of electric shock, observe the following:
1. Read all instructions before using appliance.
2. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
3. Do not remove the motor enclosure. No user serviceable parts are inside.
4. Disconnect the product from power supply when not in use, before servic-
ing, cleaning, or when changing lamps. Replace lamp with the same type rat-
ed 30 watt lamp.
5. Use only extension cords marked W-A or equivalent. Its electrical rating
must be at least 120 V, 60 Hz, and 10 Amps. Use only extension cords
which have plugs and receptacles which accept product’s plug.
6. Replace or repair damaged cords.
7. Don’t abuse the cord. Never carry the product by the cord or yank it to dis-
connect it from the power source. Keep the cord from heat, oil, and sharp
edges.
8. Extension cords & devices for retaining an extension cord connection to
the power supply cord are available at most hardware stores.
9. Keep out of reach of children.
CAUTION! To avoid risk of contamination, observe the following: Dead insects
are unsanitary. Use care in removing used cartridge.
IMPORTANT SAFETY INSTRUCTIONS
Paraclipse Mosquito Eliminator™
Page 3
SAVE THESE INSTRUCTIONS
62670 04-15-14