P.I. Engineering Dual Keyboard Adapter - Manual (Page 2)

FCC and CE Certified
Operation
FCC Declaration of Conformity
Use either keyboard interchangeably. Input from both keyboards will go
to the computer. Modifier keys pressed on one keyboard will effect input
from the other.
This device complies with Part 15 of the FCC
rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may
cause undesired operation.
Keyboards may be “hot-plugged” into the Y-key key without powering
down the computer, but do not attempt to connect or disconnect the Y-key
key to or from the port of a running computer.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
residential installation. This equipment generates, uses, and can radiate radio frequency
energy and if not installed and used in accordance with the instruction manual may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user in encouraged to try to correct the interference by one
or more of the following measures:
Toubleshooting
The Y-key key uses the standard keyboard driver already on your
operating system. Both keyboards must use the same driver. Test each
keyboard independently without the Y-key key to confirm that each will
operate on the computer.
Please contact our technical support department for help:
E-mail: [email protected]
1 Reorient or relocate the receiving antenna.
Phone: (517) 655-5523 ext.19
2 Increase the separation between the equipment and the receiver.
3 Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
4 Consult the dealer or an experienced radio TV technician for help.
Certifications Any changes or modifications not expressly approved by the manufacturer could
void the user’s authority to operate the equipment.
P.I. Engineering adapters are certified lead free.
This product should not be disposed of via the
normal household waste stream. To prevent
possible harm to the environment or human
health please separate this product from other
waste streams to ensure that it can be recycled in an environmentally
ound manner. s
For more details on available collection facilities please contact your local
overnment office or the retailer where you purchased this product. g
This information only applies to customers in the European Union. For
other countries, please contact you local government to investigate the
possibility of recycling your product.
Other Products from P.I. Engineering
Y-mouse® Adapters
Y-mouse PS/2 to USB Adapter
Y-see two Dual Monitor Adapter
Y-mouse Dual Mouse Adapter
X-keys® Programmable Devices
X-keys Foot Pedal (3 pedals) PS/2 or USB
X-keys Stick (16 keys) PS/2 or USB
XK-24 USB Keypad with backlighting (24 keys)
XK-80/60 USB Keypad with backlighting (80 keys)
RailDriver® Train Cab Controller
Controls train simulation programs.
ShipDriver™ Watercraft Controller
Controls ship simulation programs.
Please visit piengineering.com for more information.