P.I. Engineering Dual Mouse Adapter - Manual (Page 2)

Operation
Use either mouse interchangeably. Movement of the device causes
automatic switching. The first device to move or click retains control until
it stops. Mice may be “hot-plugged” into the Y-mouse without powering
down the computer, but do not attempt to connect or disconnect the Y-
mouse to or from the port of a running computer.
P.I. Engineering also makes special versions of the Y-mouse to swap the
buttons positions for left and right handed users, or to sum input from both
devices. Visit www.piengineering.com for more information.
Toubleshooting
The Y-mouse uses the standard mouse driver already on your operating
system. Both mice must use the same driver. Test each mouse
independently without the Y-mouse to confirm that each will operate on
the computer.
Please contact our technical support department for help:
E-mail: [email protected]
Phone: (517) 655-5523 ext.19
Certifications
P.I. Engineering adapters are certified lead free.
This product should not be disposed of via the
normal household waste stream. To prevent
possible harm to the environment or human
health please separate this product from other
waste streams to ensure that it can be recycled in an environmentally
sound manner.
For more details on available collection facilities please contact your local
government office or the retailer where you purchased this product.
This information only applies to customers in the European Union. For
other countries, please contact you local government to investigate the
possibility of recycling your product.
FCC and CE Certified
FCC Declaration of Conformity
This device complies with Part 15 of the FCC rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
residential installation. This equipment generates, uses, and can radiate radio frequency
energy and if not installed and used in accordance with the instruction manual may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user in encouraged to try to correct the interference by one
or more of the following measures:
1 Reorient or relocate the receiving antenna.
2 Increase the separation between the equipment and the receiver.
3 Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
4 Consult the dealer or an experienced radio TV technician for help.
Any changes or modifications not expressly approved by the manufacturer could
void the user’s authority to operate the equipment.