Deleting and loading the application program, 3 deleting and loading the application program – Datalogic Scanning Formula User Manual

Page 43

USE AND FUNCTIONING

3.3 DELETING AND LOADING THE APPLICATION

PROGRAM

This procedure allows deleting application programs developed with DS for
Formula™. If you want to delete programs provided or developed by
EasyGen™, refer to chapter 6 of the EasyGen™ manual.

NOTE

The following procedure causes data to be deleted even if not
completed.

To delete the application program, follow the instructions below:

1- Press the key and the ON/OFF power key simultaneously; the

display will show:

PROGRAM

ERASE?

Up = No Down = Yes

NOTE

If you do not want to delete the application program, press the
{▲} key or wait about 25 seconds.

2- To continue with the deletion, press the ▼ key; after a few seconds, the

display will show:

Boot from:
1. USB
2. MMC
3. Serial

Select one of the boot mode options by pressing the following keypad buttons:
-

Press 1 to select download via USB cable connection.

Press 2 to select download via MMC/SD card.

Press 3 to select download via serial cable connection.