Instructions for setup – NEMO Equipment MI User Manual

Page 9

INSTRUCTIONS FOR SETUP

Connect Pump

Connect the black valve end of your Integrated Pump to the airbeam
inflation valve. You should hear an audible click when your pump is
connected properly.

Stake Corners

Secure the anchors by pounding the stakes into the ground
with a rock or hard object. If the ground is too hard, trap the
stakes under a rock or another heavy object.

Inflate

To inflate the Mio™ airbeam with the Integrated Pump, repeat
the sequence of blowing into the mouthpiece and squeezing
the fabric pouch until squeezing becomes difficult.

Tension

Proper tension ensures maximum water shedding and wind resistance.
Once the airbeam is inflated, pull firmly on the adjustable anchors. Add
a stick to the Swallowtail end of Mio™ for better tension and venting.

Locate the black inflation valve with protective red cap. If the deflation
cap is connected, remove by pressing the button and pulling.

Locate Valves

Remember to leave no trace. Before leaving your campsite take a thorough look
around making sure you have not left anything behind, out of place, or damaged.

MIO

™

To contact NEMO Customer Service

Email: [email protected]

Phone: 800-997-9301