Desa VDCFTNB - Manual (Page 25)

www.desatech.com 116526-01B 25
opERaTiNG FiREplaCE
Continued
OPTIONAL HAND-HeLD
ReMOTe OPeRATION
Note: All remote control accessories must
be purchased separately (see Accessories,
page 40). Follow instructions included with
the remote control.
NOTICe: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions on page 23.
1. After lighting, let pilot flame burn for
about one minute. Turn control knob to
ON position. Adjust flame adjustment knob
anywhere between HI and LO. Slide the
selector switch to the REMOTE position
(see Figure 41). Note: The burner may light
if hand-held remote was on when selector
switch was last turned off. You can now
turn the burner on and off with the hand-
held remote control unit.
IMPORTANT: Do not leave the selector switch
in the REMOTE or ON position when the
pilot is not lit. This will drain the battery.
ON/OFF SeRIeS (MODeL HRC100)
Hold the control button on the hand-held remote
until burner turns on. Hold the control button
again until burner turns off (see Figure 42).
To Lock
press both buttons on hand-held
remote control until light stops flashing. Hand-
held remote control is now locked. If the fire is
on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
To Unlock
press both buttons together on
hand-held remote control until the light
stops flashing. The hand-held remote is now
unlocked.
THERMOSTAT SERIES (MODEL
HRC200)
The hand-held remote can be operated using
either the manual mode (MANU) or thermo-
static mode (AUTO) (see Figure 43). To select
Fahrenheit/Centigrade mode display, carefully
press the ˚C/˚F mode button with the end of a
paper clip or similar blunt object.
Figure 41 - Setting the Selector Switch,
Control Knob and Flame Adjustment
Knob for Remote Operation
Flame
Adjustment Knob Control
Knob
Selector Switch in Remote
Position (Optional Remote Control)
Figure 43 - Thermostat Hand-Held
Remote Control Unit
Manual Mode
1. Press the POWER and LOCK buttons
together to turn on the hand-held remote
control.
2. Press the MANU button to turn on the
fireplace.
3. Press the POWER and LOCK buttons
together to turn off the fireplace.
Figure 42 - ON/OFF Hand-Held Remote
Control Unit
Control
Button
Indicator
Light
LOCK
MANU AUTO
ºC/ºF
TEMP
POWER
ROOM
TEMP SET
TEMP
AUTO
Turns
Hand-Held
Remote On
or Off and
Allows You
to Choose
the Manual
Setting
Selects
AUTO
Mode
°C/°F
Mode
Button
Locks
System to
Prevent
Accidental
Ignition
Turns
Burners
On or
Off
Increases or
Decreases
Room
Temperature
in AUTO Mode
Digital Display Shows
Temperature and Settings Indicator
Light