Meijiaxin Toys T43 - Manual (Page 4)

Preparation for flight
Flight adjustment
1. Insert the battery plug into the helicopter battery socket located at the right side of the
helicopter, then, the indicator light of the helicopter will keep flashing rapidly, set the helicopter
down to a platform.
2. Slide the power switch to “ON” position. To activate the remote controller, slowly push up the
throttle stick to the top and then push it down to the bottom. The indicator light flashes rapidly
while the remote controller is sending out connectional signal.
3. When the whole auto signal connection process is finished, both indicator lights of helicopter
and transmitter are keep ”ON” without blinking, then push up the throttle stick slowly and the
helicopter takes off.
1.Operating
1.User may push either of the control sticks to skip the auto signal connection process once the
helicopter finished signal connection.
2.Set the connection one by one. Otherwise, it may not be connected.
3.Once the transmitter is turned off, the connection procedure must be repeated to operate the
helicopter.
4.Please pull out the battery plug from the helicopter battery socket.
OPERATIONAL TIPS
How to charge the helicopter by all-in-one charging device.
Turn off the helicopter.
Unplug the battery cable from the helicopter, then, insert the plug of the battery cable into the port
of the charger (matching the plug to the port) to start charging.
Once charging is proceeding, red light is on. When charging is finished, the red light will turn into
green light.
Full charge takes about 2 hours.