LW Measurements RKS 10,000 Round Kitchen Scale - Manual (Page 3)

CALIBRATION
Note: Calibration is done in factory. Don't re-calibrate the
Scale, unless it is not accurate.
How to calibrate
1. Before entering calibration mode, press [ON/OFF/ZERO] to turn the
power on for warming up about 1 minute.
2. Enter calibration mode
1) Press and hold [ON/OFF/ZERO] for 3 seconds to turn the scale off.
Press and hold [UNIT], then Press [ON/OFF/ZERO], the display will
show CAL then the A/D value. (a series of random numbers).
2) Press [UNIT], the display will show the flashed calibration weight value.
3) Place the calibration weight on platform.
4) Press [UNIT], the display will show "-------" then the AD value.
5) Now calibration is complete. Remove the weights.
3. Press and hold [ON/OFF/ZERO] key for 3 seconds to turn the power off.
Press [ON/OFF/ZERO] to turn on the power again. Place the weight on
the platform to make sure whether weighing is correct, if not, repeat
steps 1)-5).
5
DESCRIPTION
BACK
AC adaptor
Socket
TOP
Weighing platform
DISPLAY
UNIT key
Changes weighing units
ON/OFF/ZERO key
Turns the scale power on/off
Or set the display to zero.
BOTTOM
Battery compartment
Batteries
Use 3xAAA dry batteries
Battery compartment cover
DISPLAY
ZERO indicator Weighing unit indicator
TARE indicator
The TARE range is the full of the
max load + 9e.
Low battery indicator
2