Simply connected, Reset button, Advanced settings – Luxul XWR-1750 User Manual

Page 9: Warnings and safety information, Regulatory compliance

Simply Connected

Other trademarks and registered trademarks are the property of their respective owners

RESET BUTTON

Used to restore factory default settings

CAUTION: Holding the RESET button longer than 10 seconds will

result in a factory reset

To reset to factory defaults, press and hold the Reset button for 15 seconds.
A factory reset will take one minute or more to complete. A successful factory
reset is indicated when all of the Port LEDs flash once. When the System LED
starts flashing again the unit is ready.

CAUTION: Resetting the XWR-1750 to factory defaults will remove all

custom settings.

NOTE: To hard reboot the router, remove the power adapter. Wait 10

seconds and re-apply power.

ADVANCED SETTINGS

For advanced settings information go to luxul.com

WARNINGS AND SAFETY INFORMATION

Verify that the electrical circuits have appropriate grounding and overload protection.

Attach only approved power cords to the device.

Verify there is adequate ventilation around the device, and that ambient temperatures meet
equipment operation specifications.

The XWR-1750 is designed for indoor use only. DO NOT place this outdoors.

DO NOT install in or near hot or humid places, such as a kitchen or bathroom. Take care to
minimize exposure to excessive heat or moisture.

Small parts and plastic bags used for packaging may be harmful to small children. KEEP All
ACCESSORIES OUT OF THE REACH OF CHILDREN!

The XWR-1750 may become hot when in use for extended time periods. This is normal and is not a
malfunction. DO NOT install where it will be exposed to paper, cloth or other flammable materials.

REGULATORY COMPLIANCE

The device complies with internationally recognized standards covering human exposure to elec-
tromagnetic fields from radio devices. This equipment also complies with FCC radiation exposure
set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC
radio frequency exposure limits, human proximity to the antenna shall not be less than 20 cm (8
inches) during normal operation.