Lodar 6 Function IP Series Stainless Transmitter - Manual

!
1 2
Function Buttons
RESET Button activates the
Receiver and the keypad
function buttons
4 Release Screws for
Battery Compartment
at rear.
4 x AAA batteries
Effective working range up to a distance of
60 metres (200 feet) 92 Series and
300 metres (1000ft) 93 Series.
The Transmitter automatically
transmits a STOP signal after
30 minutes; this de-activates
the Receiver and the Transmitter.
SAFETY FEATURE
!
922TX.04E.A4
To register Transmitters to the Receiver.
Switch OFF or DISCONNECT the power to the
Receiver and briefly PRESS the STOP button
on one or both Transmitter(s).
Switch ON or Reconnect the power to the Receiver.
This opens a 20 second registration window in the
Receiver processor.
If you are looking at the Receiver PCB the Fault LED Flashes.
Immediately PRESS and HOLD both the Transmitter RESET Button
and F1 Button (indicated). Continue to hold BOTH BUTTONS
for a MINIMUM of 5 seconds during this 20 second window.
When the Transmitter is Registered the Fault LED will be illuminated for 3 seconds.
Within this 3 second period, FIRST release F1 and then the RESET button.
TO REGISTER TWO TRANSMITTERS:
When the fault light starts to flash again, and immediately PRESS and HOLD both the Transmitter RESET
F1 Buttons of the second Transmitter. Continue to hold BOTH BUTTONS for a MINIMUM of 5 seconds or
until the SET LED comes on. Both your Transmitters will now operate the Receiver.
PRIORITY.
Only one Transmitter can be active at any time. For the second Transmitter to work you have to turn off the
first Transmitter. Once the second Transmitter is being used then that has priority and it has to be turned off
before the first Transmitter can work again.
If you have any problems please phone either your local Distributor or Lodar directly:-
UK +44 1922 613633. US 1-877- 257-1581.
!
PRESS & HOLD
both RESET and F1
for a MINIMUM of
5 SECONDS
Instructions for 92/93 Series IP Transmitters
(16 Function shown)
www.lodar.com
STOP Button switches off
the Receiver and the keypad
function buttons
L.E.D.
Blinks when Transmitter
is active.
ON when a Transmitter
Button is pressed.
Pulses while transmitting
when Battery is low.
!