Dualit Kitchen Blender User Manual
Page 9
• To vary the length of the power cord/cable uncoil from
storage area beneath powerbase. FFiig
g.. 3
3
• Ensure the blender is fully assembled and in place on motor
base. Place ingredients into the jug and firmly attach the lid.
• Switch blender “on” ,the red “standby” light will flash.
• Press pulse button , green light will glow and blades
will rotate at full speed until button is released.
• Only use rubber spatula to mix foods when blender lid is
removed, the speed knob is at speed 1
1 and the blades are
stationary.
• When blending at any speed the pulse button can be
pressed for full speed and will hold full speed until pulse
button is released and speed will resume speed on knob .
• Remove cap
and add ingredients only at slow speeds.
• When using at high speed, with a full jug or with warm
contents, stop blender and then add ingredients.
• The filler cap doubles up as a key for removing the blade
assembly from the Jug for cleaning.
FILLER CAP/ BLADE KEY
TURBO PULSE
PULSE FEATURE
CORD STORAGE
9
10
1
6
8
9
9
8
8
• Switch off, unplug and un-assemble before cleaning.
• Do not let the power base, flex or plug get wet.
• Wipe power base with damp cloth, then dry.
• All other parts can be washed in dishwasher, using a low
temperature cycle, then dry.
• To clean the jug, quarter fill with warm water, add a few
drops of washing liquid and whizz for 30 seconds. Rinse.
• To remove blade for cleaning, follow procedure on page 5.
• Do not touch the blades - brush clean under a tap/faucet.
Then leave to dry out of children’s reach.
• Warning: Do not immerse or wash jug in boiling or
very hot water above 60°c.
.
If the power cord is damaged it must, for safety reasons,
be replaced by Dualit or an authorised Dualit repairer.
If blender fails to operate refit lid ensuring correct positioning
of the plunger into the Safety Interlock System and/or unplug
for 15 minutes, plug in and try again.
Ensure the blade assembly is correctly fitted.
If problems persist, either contact the shop where you
purchased from, or telephone Dualit.
In UK call Dualit Care Line 01293 652 500 or
email:[email protected]
REPLACEMENT CORD / SAFETY SYSTEM
CLEANING
050107_Quark file for Blender.qxp 1/10/2007 10:59 Page 9