Lingenfelter L850151410 Camaro Rear Deck Spoiler v0.8 - Manual (Page 8)

Page 7.
17. The two (2) bumpers that are included
in the kit are used to prevent scratching due to
overslam on the right and left sides of the quar-
ter panel. Place these bumpers in the position
shown. You may place these either on the under-
side of the spoiler or on the vehicle itself.
18. Re-install the rubber seals that you re-
moved in step 5 by pushing the center of the seal
inward until it snaps into place.
19. Re-install the carpet lining, trunk release
lever and the latch guard.
20. If needed, the replacement emblem should
be installed at this time. The installation of the
LPE rear spoiler is now complete.