Lingenfelter L710050607 Lingenfelter Suburban & Yukon XL Fuel Pump 2007 v1.1 - Manual (Page 7)

L710050607 2007 Suburban & Yukon XL Fuel Pump Upgrade Kit v1.1.indd
1557 Winchester Road
Decatur, Indiana 46733
260 724 2552 phone
260 724 8761 fax
www.lingenfelter.com
Page 6 of 6
24) Connect the fuel pump hose to the top of the fuel filter.
25) Connect the fuel pump harness connector to the top of the module.
26) Follow the GM service instructions for
installing the fuel pump module back into
the vehicle. Use the supplied replacement
fuel pump module O-ring.
Congratulations, you have completed the
installation.
This pump flows roughly 50 gph at 60 psi at 12
Vdc, 60 gph at 13.5 Vdc and 75 gph at 16 Vdc.
Some of this flow is used to run the jet pump
(venturi pump) that fills the fuel pump “bucket”
or canister. Without voltage boosting, this
should be enough fuel flow to support roughly
650 to 700 hp naturally aspirated and 550 to
650 hp in turbocharged/supercharged applications. For boosted applications above 650 hp and naturally
aspirated applications above 700 hp, we recommend voltage boosting the pump to 16 or 17 volts with
a Boost-A-Pump. At high fuel flow rates it may be possible to empty the module (“bucket”) faster than
the jet pump can fill the module so make sure you do not run low fuel levels when running at high
power levels.