Lingenfelter L350080197 Lingenfelter C5 Corvette Mini Tub Kit User Manual

Page 14

Page 13.

44. Remove the matting that rests on the

vertical walls of the fender-wells and the excess

matting in a 2” strip running the length of the

fender-well.

45. Sand the plastic panels that come in

contact with the fender-well as necessary,

remove the staples and re-install the carpet.

There are some sections that you will need to

trim in order to fit the new tub kit.

NOTE: If your vehicle comes equipped with a

storage compartment you will need to trim the

carpet as necessary to fit.

46. Check all brake lines and wiring for

clearance, tie back as necessary.

2001-2004 ZO6 Corvette. Brake Vent Block Offs: Not included in kit

Remove all rear brake cooler ductwork; they cannot be used due to tire clearance. Remove the vent

section that is bolted to the body. Paint the block-off plates black on the side that will be exposed.

Start the block-off plate into the duct-section from the backside. It will appear to be too large. Use a

large screwdriver to force it all of the way down against the mesh. You will need to work it in slowly to

prevent deformation. After the plate is seated run a bead of black silicone around the backside. This

block-off plate is necessary to prevent air from applying pressure and deforming the plastic fender

liner, which can cause tire to tub interference.