LG Motorsports ZR28 Hood User Manual
Page 2

Prep surface of hood for first prime using 150 grit paper with a soft block. The idea is
to scuff the surface without breaking into the surface. Use 3M Scotch-brite pad to
further scuff the surface.
1. Blow of all dust and clean surface with wax‐grease remover.
2. Identify any surface imperfections/pin holes before first prime. Fill any imperfections
with high quality filler or Evercoat glaze.
3. First prime: Use Evercoat Polyester primer Slick Sand to lock in surface and give the
hood a long lasting hard surface. Apply 2 heavy coats.
4. Light bake up to 135 deg. for 30 minutes.
5. Block sand hood with 150 grit paper
6. Second prime: Apply 2 more heavy smooth coats of epoxy based urethane primer. Light
bake for 30 minutes.
7. Guide coat and wet block sand with 400 grit paper for optimum paint adhesion.
8. Follow final paint procedures for top‐coatings wet sand and rub.
9. Very Important!!! Upon installation of hood transfer the two existing 10 mm
head bolts to new hood to further secure the hood front latch plate next to the
front striker.
8.
Re-attach to the factory hinges for final alignment and install.
Lou Gigliotti
President LG Motorsports
LG Motorsports is not responsible for any improper install, modification to product, or
any changes made by installer to product. Any welding or modification will void any
product warrantee. LG Motorsports or the dealer is not liable for any loss, damage, or
injury due to the direct or indirect use of this product.