LG Motorsports LG C6 Z06 Pro Long Tube Headers - Manual

LG Pro Long Tube Headers
2006 Corvette Z06
“THE MOST POWERFUL HEADERS ON THE PLANET”
Brought to you by LG Motorsports
972-429-1963
Thank you for purchasing LG headers for your C6 Z06 Corvette.
Parts Inventory:
1. Driver side header
2. Passenger side header
3. X- pipe with 02 sensor bungs
4. 2 high flow cats OR 2 cat delete pipes
5. Driver side rear flow tube
6. Passenger side rear flow tube
7. 8 3” stainless steel band clamps
8. 1 pair of LGM metal layer gaskets
9. 1 pair of black front 02 sensor extension wires
10. 1 pair of white rear 02 sensor extension wires
Instructions:
Removal:
Start by supporting the car on a lift, or 4 jack stands on a level surface about two
or more feet off of the ground. Disconnect negative battery cable before any work
begins. You will need to make note of the rear over the axle pipes and the spacing they
have between the frame because you will need to keep this same spacing after the
installation of the header system as to not have any rattles at the rear of the car as the
factory has placed 3” exhaust tubes here and the space is limited.
Once noting the placement of the stock exhaust parts you will need to start by
removing the old exhaust components. Start by removing the fuel rail covers on top of
the engine. These simply unclip and pull off. The driver side is a little trickier as you
need to route the fuel line through the cut out in the cover. Once that is done then set
them aside. You will also have to unbolt and remove the oil dipstick from the passenger
side of the engine.
Move on to removing the spark plug wires and spark plugs from the engine. Be
careful not to drop any of the spark plugs as this will damage the plug and cause a misfire