End panel layout – Directed Electronics ORION 8004 User Manual
Page 6
END PANEL LAYOUT
1.
Power LED - when lit indicates that the amplifier is on.
2.
Front Low-Pass Crossover Switch - activates 2nd order low-pass crossover.
3.
Front Low-Pass Frequency Control - adjusts the frequency of the low-pass
crossover.
4.
Front Gain Control - continuously adjusts from 200mV to 5V for full power output.
5.
Front High-Pass Crossover Switch - activates 2nd order high-pass crossover.
6.
Front High-Pass Frequency Control - adjusts the frequency of the high-pass
crossover.
7.
Front RCA Inputs - accepts RCA input from a source unit, preamplifier, or equalizer.
8.
Rear RCA Inputs - accepts RCA input from a source unit, preamplifier, or equalizer.
9.
RCA Outputs - provides easy connection to additional amplifiers.
10. Rear Gain Control - continuously adjusts from 200mV to 5V for full power output.
11. Copy/Master Switch - determines the output of the RCA outputs.
12. Rear Low-Pass Crossover Switch - activates 2nd order low-pass crossover.
13. Rear Low-Pass Frequency Control - adjusts the frequency of the low-pass
crossover.
14. 4CH / 2 CH Switch - configures the amplifier for one or two sets of inputs.
15. Rear High-Pass Crossover Switch - activates 2nd order high pass crossover.
16. Rear High-Pass Frequency Control - adjusts the frequency of the high-pass
crossover.
17. INTELLi Bass Control - continuously adjusts from 0 to 10dB of boost on the rear
channels.
18. Speaker Connections - allow up to 12 gauge speaker wire.
19. 1 x 80A MAXI Fuse - protect the amplifier from over current situations.
20. REM Remote Turn-on Input - turns on the amplifier when fed 12 V+.
21. Power Connections - allow greater than eight-gauge power and ground cables.
5
©2003 Directed Electronics, Inc.