Laerdal AED Trainer 3 - Manual (Page 11)

11
SETUP
CONNECTING THE TRAINING PADS
The AED Trainer 3 may be used with either HeartStart Training Pads III or Laerdal LINK Technology Training Pads.
HEARTSTART TRAINING PADS III
To connect the HeartStart Training Pads III to the AED Trainer 3, follow the steps below.
1 Remove the HeartStart Training Pads III from their storage bag, leaving them on their liner.
2 Remove the interconnect cable from its storage bag. Connect the pads cable to the interconnect cable.
NOT FOR
CLINIC AL US
E NOT FO
R
CLINIC AL US
E
TRAININ
G
TRAINING
3 Plug the interconnect cable’s yellow connector into the pads connector socket on the front of the AED Trainer 3.
Be sure the connector clicks into place.
4 Place the AED Trainer 3 with the pre-connected pads in the carry case. The case is designed to store the AED Trainer
3 with the pads pre-connected.
The HeartStart Training Pads III are designed for up to 100 uses. To help ensure continued performance, avoid leaving the
pads in heat or direct sunlight. To replace the pads, disconnect the connector plug from the AED Trainer 3 and repeat
Steps 1 through 3, above.