Dolby Laboratories V07TV13 - Manual (Page 20)

20
EN
O
PTIONAL SETTING
B. MPAA Rating B. MPAA Rating
MPAA Rating is the rating system created by MPAA (Motion Picture
Association of America).
4
Use [CH K /L] to select “MPAA RATING”, then press
[VOL X].
e.g.) digital TV mode
or
CH
CH
VOL
- V - CHIP SETUP -
TV RATING
MPAA RATING
DOWNLOADABLE RATING
CHANGE PASSWORD
5
Use [CH K /L], then press [VOL X] repeatedly to
change the setting.
or
CH
CH
VOL
G [VIEW]
PG [VIEW]
PG-13 [VIEW]
R [BLOCK]
NC-17 [BLOCK]
X [BLOCK]
Rating Category
G General audience
PG Parental guidance suggested
PG-13 Unsuitable for children under 13
R
Restricted; under 17 requires accompanying
parent or adult guardian
NC-17 No one under 17 admitted
X Mature audience only
6
Press [MENU] to exit.
MENU
C. Change Password C. Change Password
Although the default code “0000” is supplied with the unit, you can set
your own password.
4
Use [CH K /L] to select “CHANGE PASSWORD”, then
press [VOL X].
e.g.) digital TV mode
or
CH
CH
VOL
- V - CHIP SETUP -
TV RATING
MPAA RATING
DOWNLOADABLE RATING
CHANGE PASSWORD
5
Press [the Number buttons] on the remote control to
enter the new 4-digit password.
• Enter password again in “CONFIRM PASSWORD”
space.
3 2 1
6 5 4
9 8
0
7
NEW PASSWORD
_ _ _ _
CONFIRM PASSWORD
_ _ _ _
6
Press [MENU] to exit.
MENU
Note:
• Make sure new password and confirm password must be
exactly the same. If they are different, the space is cleared
for reentering.
• Your password will be erased and return to the default
(0000) when a power failure occurs. If you forget the
password, unplug the power cord for 10 seconds to restore
the password to 0000.