Dolby Laboratories V07TV13 - Manual (Page 12)

12
EN
W
ATCHING TV
Channel Selection
Select channels by pressing [CH K /L] or [the Number buttons].
• To select the memorized channels,
use [CH K/L] or [the Number buttons].
• To select the non-memorized channels,
use [the Number buttons].
To use [the Number buttons]
TV
- When selecting analog channel 12
2 1
DTV
- When selecting digital channel 12-1
Be sure to press [–/ENT] before entering the minor
channel number.
–/ENT
2 1 1
• Press [CHANNEL RETURN] to return to the previously
viewed channel.
• When you select a channel larger than 100,
press [+100] first. Then use [the Number buttons] to
press the lower 2-digit numbers.
About digital TV broadcasting:
With its high definition broadcast, digital broadcasting
far surpasses analog broadcasting in both its picture
and sound quality.
What is the minor channel?
By using high compression technology, digital
broadcasting offers a service that enables multiple
signals to send simultaneously.
Therefore, you can select more than one program per
major channel since digital broadcasting technology
distinguishes between multiple channels broadcast by
a single network.
CH4
CH4
(high definition TV)
18:00
18:30
19:00
19:30
20:00
20:30
CH4-1
CH4
CH4
No signal
No signal No signal
CH4-2
ATSC (digital mode)
CH4
NTSC (analog mode) [Air Time]
No signal
CH4-1 CH4 CH4-2
: change automatically
major channel minor channel
: change manually by using [CH / ]
Although, you cannot watch the high definition TV
(HDTV) program, the unit converts the HDTV signal
down to the standard definition TV signal.
Note:
• “NO SIGNAL” will appear on the TV screen after the minor
channel broadcast is over.
5 Volume Adjustment
This section describes how to adjust the volume.
The mute function, which turns the sound off and on, is also described.
Use [VOL X/Y] to adjust the audio volume.
or VOL VOL
VOLUME 20
• The volume bar will be displayed at the bottom of the
TV screen when adjusting the volume.
• The volume bar display will automatically disappear in
a few seconds.
Press [MUTE] to turn off and on the sound.
MUTE
MUTE 20
• “MUTE” is displayed on the TV screen for a few
seconds.
Press [MUTE] again or [VOL X/Y] to recover the original
volume.
5