Labconco Purifie Non-Ventilated PCR & Tissue Culture Enclosures 3952420 - Manual (Page 17)

Product Service 1-800-522-7658 13
C
HAPTER
5
U
SING
Y
OUR
E
NCLOSURE
Planning
• Thoroughly understand procedures and equipment required before
beginning work.
• Arrange for minimal disruptions, such as room traffic or entry into the
room while the enclosure is in use.
Start-up
• Clean and surface disinfect the inside of the enclosure. Use UV light as
required for protocol.
• Turn on the fluorescent light.
• Only raise the sash for loading.
• Wear a long sleeved lab coat and rubber gloves. Use protective eyewear.
Wear a protective mask if appropriate. Consult your Safety Officer for
additional personal protective equipment recommendations.
Work Techniques
• Keep all materials inside and perform all operations inside the work area.
Unloading Materials and Equipment
• All open trays, weigh vessels and containers should be covered before
being removed from the enclosure.
Shutdown
• Turn off the fluorescent light and install the UV sash closure panel.
• Clean and surface disinfect the interior surfaces after completion.
• Turn on the UV light to decontaminate the work area as determined by
your protocol.