Konig Electronic Blood pressure monitor upperarm - Manual (Page 6)

6
11. TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
LCD Display
shows battery
symbol
Low Battery Change all batteries
LCD Display
shows “EE”
Arm or blood pressure monitor
was moved during testing
Re-test taking care to not move your arm or the blood pressure
monitor
The cuff does not inflate properly
or pressure falls quickly during
testing
Ensure that the rubber tube is fully inserted into the blood pressure
monitor
Irregular heartbeat (arrhythmia)
People with light arrhythmia may re-test.
It is inappropriate for people with serious arrhythmia to use this
blood pressure monitor.
The blood pressure monitor did
not inflate sufficiently.
The cuff was not properly wrapped
or the rubber tube was bent or
pressed.
Review the cuff wrapping and testing sections of the instructions
and re-test.
LCD Display
shows abnormal
result
The cuff position was not correct
or it was not properly tightened
Apply the cuff correctly and try again
Body posture was not correct
during testing
Review the body posture and testing sections of the instructions
and re-test.
Speaking, arm or body movement,
angry, excited or nervous during
testing
Re-test when calm and without speaking or moving during the test
No response
when you press
button or load
battery
Incorrect operation, or strong
electromagnetic interference
Take out batteries for five minutes, and then reinstall all batteries.
Maintenance
1. Do not drop this monitor or subject it to strong impact.
2. Avoid high temperature and polarization. Do not immerse the monitor in water as this will result in damage to the
monitor.
3. If this monitor is stored near freezing, allow it to acclimate to room temperature before use.
4. Do not attempt to disassemble this monitor.
5. If you do not use the monitor for a long time, please remove the batteries.
When the cuff is dirty, detach it from the equipment, wash the cuff by hand with proper detergent and rinse in
cold water. Dry in air. Never iron.
EXPLANATION OF SYMBOLS ON UNIT
Symbol for “Caution Consult Accompanying Documents”
Symbol for “Type B Applied Parts”
CE is a kind of marking of EU safe attestation. This product matches MDD93/42/EEC
Safety precautions:
To reduce risk of electric shock, this product should ONLY be opened by an authorized
technician when service is required. Disconnect the product from mains and other
equipment if a problem should occur. Do not expose the product to water or moisture.
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage caused due to
incorrect use of this product.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION