Konig Electronic Wireless RF speakers - Manual (Page 3)

3
Description loudspeakers:
1. Battery compartment 5. Volume
2. Bass Boost 6. DC input
3. Auto Tuning 7. Left/Mono/right selector
4. Power (red)/reception (green) indicator
Operation loudspeakers:
1. Insert 6 pieces ‘AA’ size ALKALINE batteries into the battery compartment according to the correct
polarity at the rear of the speakers or connect the 12 V power adapter to the DC input jack on the
rear of each speaker, then plug it to the wall outlet.
2. Switch on the speakers by turning up the VOLUME ON/OFF knob towards the ON direction. The
POWER/STEREO LED will light up. Switch off the speakers by turning down the VOLUME ON/OFF
knob towards the OFF direction until a “click” sound can be heard.
General operation:
1. Turn on the audio source to which the transmitter is connected. The signal LED on the transmitter
will light up.
2. Select channel 1 or 2 of the transmitter for best performance at your location. Whenever you find
a distorted frequency, move your channel switch from one channel to the other channel (there are
two channels for selection) on the transmitter, and then press the “SCAN” auto-tuning button on the
speaker again.
3. Select the L/Mono/R selector on the speaker receivers, one to L and the other to R for the best
stereo reception. In case the audio device only provides a mono audio signal, select the MONO/ST
selector to MONO for the best mono reception.
4. Turn on the ON/OFF VOLUME knob on the speaker and adjust the volume to the desired listening
level.
5. Push the “SCAN” auto-tuning button to get the best tuning reception from the speakers. When the
button is pressed, frequency tuning starts automatically and it stops when a signal is detected. The
POWER/STEREO LED will change from red to green.
Note: you should now be able to place the speakers freely from room to room without disruption.
If disruption should occur (signal breaks up), press the speaker’s “SCAN” auto-tuning button to
maximize best reception. If you hear interference from other components, switch the channel
control of the transmitter, and then move the speakers to another free location. You can re-adjust
the tuning control by moving it either to channel 1 or 2 of the transmitter, then pres “SCAN”
auto-tuning button for best reception. When transmitting/receiving over long distances, the signal
from the system will become weaker.