Konig Electronic Bluetooth design headset - Manual (Page 3)

3
2. Pairing the headset with Bluetooth devices
2.1. How to enter the pairing mode
Function Operation LED indicator Indication tone
Enter into pairing
mode
First, make sure the headset
is off. Press O for 5-7 seconds
and release until the red and
blue LEDs blink alternately
The red and blue LEDs blink
alternately
Two tones
Note:
* The pairing mode will last 2 minutes. If the headset still cannot pair with any Bluetooth devices, it will
automatically switch into standby mode.
2.2. Pairing the headset with a Bluetooth mobile phone
Please make sure your mobile phone has a Bluetooth function.
Specific pairing procedures may vary with different mobile phones. Please refer to your mobile phones’
manual for further information. The steps are as follows:
a. Please keep the headset and mobile phone within 1 metre of each other when pairing
b. Make the headset enter the pairing mode (please refer to 2.1)
c. Switch on the Bluetooth function of the mobile phone and search for Bluetooth devices. When the search
is completed, select the headset in the Bluetooth device list.
d. When prompted, enter PIN No: “0000” as the password and press “Yes” or “Confirm”.
e. After pairing the devices successfully, select the headset in the Bluetooth device list and press “Connect”.
f. If the connection is successful, the blue (or red) LED of the headset blinks twice every 4 seconds.
Note:
* If the pairing is not successful, please switch off headset first then try to pair them again according to the
steps mentioned above.
* After pairing, the devices will remember each other.
* The headset will connect with the last paired device. If you want to pair it with other Bluetooth devices,
please switch off the Bluetooth function of the current Bluetooth device, then pair and connect the new
Bluetooth device according to steps mentioned above.
3. Pairing the headset with a Bluetooth transmitter
You can enjoy music wirelessly by connecting the headset with a stereo Bluetooth transmitter. See the
manual of your transmitter for more details.
4. Making a call with the headset
Function Status of the headset Operation Indicator tone
Voice dial Standby mode Press O for 2 seconds
and release until a tone is
heard
A long tone
Redial last number Standby mode Briefly press O twice A long tone
Volume up Conversation mode Briefly press + and then
release (or hold) it
None
Volume down Conversation mode Briefly press – and then
release (or hold) it
None
Answer call Ringing Briefy press O A short tone
Reject call Ringing Press O for 2 seconds
and release until a tone is
heard
A short tone
End call Conversation mode Briefly press O A short tone
Switch conversation
between headset and
mobile phone
Conversation mode Press O for 2 seconds
and release until a tone is
heard
A short tone