DCS BGB132-BI - Manual (Page 14)

13
GENERAL CLEANING
BURNERS
For proper lighting and performance
keep the burners clean. It is necessary
to clean the burners if they do not light
even though the igniter clicks, if there
has been a severe boil over, or when
the flame does not burn blue.
Be
certain all burner knobs are in the off
position before attempting to clean the
burners.
The burners have been
designed for ease in cleaning. When
the grate and burners are cool, remove
the grate. The burner cap and the brass
port ring can easlily be lifted off. Wash
these parts in hot soapy water, rinse
and dry thoroughly. The burner caps
are porcelain enamel, follow the
directions on the previous page that
were given for the burner grates. A
bristle brush can be used to clean out
the toothed burner ports, if necessary.
After cleaning, it is important to make
sure the location pins on the bottom
side of the port ring are properly
aligned with the corresponding holes
in the base. Incorrect alignment will
produce a potentially dangerous
flame and poor burner perfomance
(see Fig.09).
IGNITERS
Wipe with a water dampened cotton swab. Be careful
not to damage the igniter (see Fig.10)
FIG.10
IGNITER (KEEP CLEAN)
FIG.09
Brass Ring
Locating Pins
Electrode
Main
Burner
Port
Ring
Locating Notch
Burner
Base
Venturi
Cap
Locating Holes