Kent Razo SV17 - Manual (Page 11)

INSTRUCTIONS FOR USE
Razor SV17
— 909 6309 000(1)2006-01 9
MACHINE OPERATION (SCRUBBING/DRYING)
1. Start the machine according to the procedure shown in
the previous paragraph.
2. While keeping both hands on the handlebar (2, Fig. C),
move the machine and start scrubbing/drying the floor.
3. If necessary, adjust the solution flow sent to the brushes
by turning the lever (4, Fig. C).
Battery discharge during operation
4. Until the green warning light (2, Fig. B) stays on, the
batteries allow the machine to operate normally.
When the green warning light (2) turns off and the yellow
(3) and red (4) warning lights turn on in sequence, it is
necessary to charge the batteries.
Machine speed adjustment
5. The machine speed varies according to the type of floor
to be cleaned and the choice of using the brush or the
pad.
If necessary, it is possible to adjust the machine speed
by following the relevant procedure in the Maintenance
chapter.
MACHINE TRANSPORT/PARKING
To transport/park the machine, proceed as follows.
1.
Turn the brush/pad switch and the vacuum switch (5 and
6, Fig. B) to “0”.
2. Lift the squeegee by means of the lever (19, Fig. C).
3. Grasp the handlebar (2, Fig. C) and slightly lower it until
the rear wheel (7, Fig. C) comes into contact with the
floor (Fig. D). While holding the machine in this position,
push it to the transport/parking area.
4. After finishing the work, in order not to drag the
brush/pad on the floor and leave wet marks, remove the
brush/pad from the deck by using the release device (for
the procedure, see the After Using The Machine
paragraph), then place it on the support (3, Fig. J).
TANK EMPTYING
An automatic float shut-off system (6, Fig. J) stops the
vacuum system when the recovery water tank (4) is full.
The vacuum system deactivation is signalled by a sudden
increase in the vacuum system motor noise frequency.
When the recovery water tank (4, Fig. J) is full, empty it
according to the following procedure.
Recovery water tank emptying
1. Stop the machine by pressing the brush/pad and
vacuum switches (5 and 6, Fig. B).
2. Lift the squeegee by means of the lever (19, Fig. C).
3. Drive the machine to the appointed disposal area.
4. Insert the positioning pin (24, Fig. C) and lift the
brush/pad by activating the transport/parking device
(23a).
5. Empty the recovery water tank by means of the drain
hose (16, Fig. C).
Then, rinse the tank with clean water.
Solution tank emptying
6. Carry out steps 1 to 4.
7. Empty the solution tank by means of the drain valve (18,
Fig. C).
Then, rinse the tank with clean water.
CAUTION!
To avoid damaging the floor surface:
–
Do not use the brush/pad without the
solution.
– When the machine is stopped, stop the
brush/pad by pressing the switch (5, Fig.
B).
CAUTION!
Before lifting the brush/pad, stop its rotation
by pressing the switch (5, Fig. B).
CAUTION!
Do not use the machine with discharged
batteries, to avoid damaging the batteries and
reducing their life.