JUGS Sports 101 (2 wheel) Baseball Pitching Machine - Manual (Page 13)

11
Unpacking
WARNING: To prevent accidental starting, or electrical shock that could
cause possible serious injury, assemble all parts to your
machine before connecting it to the power supply. The pitch-
ing machine should never be connected to a power supply
when you are assembling parts, making adjust-ments, clean-
ing, servicing, or when you are not using it.
• Carefully lift the machine from the carton and place it on a level surface.
• Make sure you have all the parts (see nomenclature, page 10). If any
parts are missing, do not operate the machine until the missing parts are
replaced. Failure to do so could result in possible serious personal injury.
• Do not discard the packing materials until you have carefully inspected the
machine, identified all the parts, and satisfactorily operated the machine.
NOTE: If any parts are damaged or missing, do not attempt to plug in the
power cord and turn on the switch until the damaged or missing parts are
obtained and are correctly installed.
Set Up
1. With the tire side down, place the triangular leg clamp in the leg clamp
casting.
2. Insert the threaded end of the T-handle through the center hole in the leg
clamp casting, and start the threads.
3. Install one leg in each round hole in the center piece of the leg clamp
casting. Tighten the T-Handle sufficiently to hold the legs very snugly in
place.