Dell fi-412PR - Manual (Page 10)

6 |
5. Insert the screws attached to the Fix Tabs into the
two positions in the rear of the Imprinter; and
tighten them to secure the imprinter to the
Scanner.
6. Join the Imprinter cable (EXT Cable) to the
connector in the rear of the Scanner.
ATTENTION
The Imprinter will not work if the EXT cable is
not connected to the Scanner. Scanning
when the EXT cable is not connected can
cause documents to jam inside the Imprinter.
7. Replace the Stacker (removed in procedure 2) to
the Imprinter.
8. Connect the power cable to the scanner.
d Reconnect the other arm by
sliding it in gently.
c Insert one arm.