Hobbywing EZRUN-150A-PRO - Manual (Page 2)

User Manual of EZRUN-150A-PRO Brushless ESC HW-SM405ENG-20120630 Page - 1 -
Declaration
Thanks for purchasing our Electronic Speed Controller (ESC). High power system for RC model can be very
dangerous, so we strongly suggest you read this manual carefully. In that we have no control over the
correct use, installation, application, or maintenance of our products, no liability shall be assumed nor
accepted for any damages, losses or costs resulting from the use of the product. Any claims arising from the
operating, failure of malfunctioning etc. will be denied. We assume no liability for personal injury,
consequential damages resulting from our product or our workmanship. As far as is legally permitted, the
obligation to compensation is limited to the invoice amount of the affected product.
Features
 Compatible with all sensorless brushless motors
 Excellent start-up, acceleration and linearity features.
 3 running modes (Forward only with brake, Forward/Reverse with brake, Forward/Reverse immediately)
 4 steps of maximum reverse force adjustment.
 Proportional ABS brake function with 4 steps of maximum brake force adjustment, 8 steps of drag-brake force
adjustment and 4 steps of initial brake force adjustment.
 9 start modes (Also called “Punch”) from “very soft (Level 1)” to “very aggressive (Level 9)”.
 Multiple protection features: Low voltage cut-off protection / Over-heat protection / Throttle signal loss protection
/ Motor blocked protection.
 8 steps of timing adjustment by software.
 Built-in switch mode BEC has a powerful output to supply all the electronic equipments.
 Easily program with only one button and compatible with pocket-sized Program Card.
 Splash proof and dustproof.
Specifications
Model EZRUN-150A-PRO
Cont./Burst Current 150A/1080A
Resistance 0.0002 ohm
Suitable Car
1/5, 1/8 on-road and off-road cars / trucks
for competitive race
Suitable Brushless Motor ≥3.5T (Note 1)
Battery
6-18 cells Ni-xx (NiMH or NiCd)
2-6 cells Li-Po
BEC Output 5.75V/3A of switch mode built-in BEC (Note 2)
Motor Type Sensorless brushless motor
Dimension 68(L)×55(W)×45(H)
Weight 150g(Without wires)
Note 1: The value of “T” number is tested under the input of 4 cells Lipo battery;
Note 2: The cooling fans of ESC and motor are supplied by the built-in BEC, so they are working under 5.75V.
Begin To Use The New ESC
WARNING! THIS BRUSHLESS SYSTEM IS VERY POWERFUL! FOR SAFETY, PLEASE ALWAYS KEEP THE
WHEELS AWAY FROM THE TRACK WHEN YOU BEGIN TO SWITCH ON THE ESC.
1. Connect the ESC, motor, receiver, battery and servo according to the following diagram
Note3: There is a small female connector that coming out from the “FAN” socket, this is used for connecting with the
cooling fan of the brushless motor.
If there are 2 battery packs need to be connected in
series, please refer to the following picture: