HITEC Telemetry System - Manual (Page 5)

10 11
2.4Gz Telemetry Product Installation Guide 2.4Gz Telemetry Product Installation Guide
HTS-SS HTS-SS
6. Launch the HPP-22 PC program
7. Under the Product menu, select “etc”
8. As the target select SPECTRA 2.4 Module
9. Select Yes when prompted for “Sensors data display?”
10. At the sensor display screen note all the
information displayed.
11. Use the record and play functions to
record flight data.
8. HPP-22 PC Interface
8. HPP-22 PC Interface 7. GPS Sensor
The HPP-22 PC interface device is a handy accessory to have. In addition to updating the Aurora, Spectra 2.4 module,
Optima receivers and the HTS-SS sensor station, the HPP-22 when ported to the Spectra 2.4 module can display the flight
telemetry data on a PC. This flight data can be recorded and played back at a later date.
Using the HPP-22 to display, record and playback flight data
1. Install the HPP-22 software from the Hitec website at www.hitecrcd.com
2. Plug the device into an empty USB port on your PC.
3. Plug an S connecter cable into the HPP-22’s P1 port and the other end into the Spectra 2.4 module.
4. Turn on Aurora and select “OK” to transmit.
5. Turn on aircraft with sensors connected
Aurora transmitter interface
a. As with most all sensor data, the Speed
and Altitude information derived from the
GPS is shown on the Auroras Cockpit screen.
This is reached in the System > Sensor >
Cockpit menu.
b. The specific Latitude and Longitude
position data is only shown in the System >
Sensor > GPS menu. Along with this
information is other pertinent data, GPS
strength bars, date, time, altitude and speed
are available.
c. To change the date, Unit of measurement
and to select ABSOLUTE, (above-ground-
level) or RELATIVE, (above sea level) altitude
values, press the Setting icon
d. Pressing the +RST- icon will change the
time values. Select the door icon to exit the
menu.
1. The first time the system boots during a flying session, the GPS acquisition time will be slower than on
subsequent boot-ups during any 4 hour period.
2. GPS signal may be lost during extreme 3D maneuvers.
3. For the most accurate altitude information select the ABSOLUTE setting.
Note