HITEC ENERGY SPORT ESC SERIES - Manual (Page 3)

SAFETy FEATURES [CONT.]
If this occurs, we recommend you promptly land your plane and
determine the cause of the overheating.
Lost Signal Protection: The ESC will automatically cut power to the
motor when it detects a loss of throttle signal for 2 seconds, then the
motor will emit a continuous beeping tone.
CONNECTORS
Hitec speed controls come pre-wired with motor and battery
connectors. If these connectors are not appropriate for your
application and you wish to change them, use the following
guidelines:
• Make sure they are rated at or above the amperage of the ESC.
• Always use new connectors.
• Make sure the cables and soldering posts are insulated with shrink
tubing.
• Make sure the battery is soldered with the correct polarity.
CONNECTING THE ESC
It is best to connect your ESC in the following order:
1. Connect the motor leads to the motor.
2. Connect the S Type receiver lead to the throttle channel of your
receiver.
3. Connect the battery connector to the battery.
Warning
Note
Tip Tip
Tip Caution
When initially installing your ESC, it is recommended
that you remove the propeller for safety purposes.