HITEC Aggressor CRX - Manual (Page 5)

E) Servo Reversing
- After entering the main edit mode press the "FUNC" button to scroll to the servo reversing menu.
- Press the "SEL" button to move the curser to select ST for steering, THRO for throttle or
AUX for the third auxiliary channel.
- Once the proper channel is selected, press the "DATA" + and - buttons at the same time to
reverse the servo.
- If properly done you will hear one "beep" and the solid square icon will move from
"NOR" (Normal) to "REV" (Reverse) or vice versa.
- Press the "FUNC" button to scroll to the next menu.
This menu allows you to set up your model with the settings you will only need to
assign once. You will typically not need to access this menu unless setting up a
new model. The main edit mode screens will appear in the following order:
1. Model Naming
2. Model Copy
3. Model Reset
4. Servo Reversing
5. Timer
6. Ch #3 Switch Set
6. Main Edit mode
A) Entering the Main Edit Mode
- Access the menu by holding the "FUNC" (function) button down while turning the
transmitter power switch on at the same time.
- The model naming should appear if it done right. Repeat the procedure if it does not.
Programming
F) Timer
- After entering the main edit mode press the "FUNC" button to scroll to the timer menu.
- Press the "SEL" button to move the curser to select minutes or seconds.
- Press the "DATA" + or - buttons to select the time you wish to count down to,with a max of 59:59 or
set it to 00:00 to count up.
- To activate the timer when using the radio, push the "SEL" button.
- To pause the timer, push the "SEL" button again, and then push it again to restart.
- To cancel the timer, push the "FUNC" button.
- To reset the total time on the timer, push the "DATA" + and - buttons at the same time.
- Note: The number that appears in the same place where the timer is displayed is the total time in
hours and minutes that the transmitter has on since it was last reset.
D) Model Reset
- After entering the main edit mode press the "FUNC" button to scroll to the model reset menu.
- To reset the model you are programming, press the "DATA" + and - buttons at the same time to
complete the reset procedure.
- If properly done you will hear two "beeps".
- Note: If you do not hear the double beep then try again.
- Be aware that all the setting will be reset to factory default so anything previously set will be lost.
- Press the "FUNC" button to scroll to the next menu.
B) Model Naming
- Press the "DATA" + or - buttons to select the proper letter or symbol.
- Press the "SEL" (select) button to move the curser.
- After the name is set, press the "FUNC" button to scroll to the next menu.
- Note: Be aware that you have to select the model you wish to name in the Programming mode first.
C) Model Copy
- After entering the main edit mode press the "FUNC" button to scroll to the model copy menu.
- The master is the model currently selected in the programming mode.
- The slave can be any model you choose, but be aware it will overwrite any existing
programming so be careful not to wipe out a model you have already set up.
- Press the "DATA" + or - buttons to select the slave model you wish to copy to.
- Once the slave model is selected, press the"DATA" + and - buttons at the same time to complete
the copy procedure.
- If properly done you will hear two "beeps".
- Note: If you do not hear the double beep then try again.
- Press the "FUNC" button to scroll to the next menu.