Step 2, Step 3, Step 4 step 5 – HITEC Zipper User Manual

Page 5

Text mode
Original mode

Step 2: Main Wing Assembly

Install the wing by sliding the tab on the front

of the wing into the fuselage while guiding the

servo leads through the hole. Insert the 2.0 x

16mm screw and tighten until snug.

Step 2

Step 3: Spinner Assembly
Place the foam spinner over the propeller.

Step 3

While not necessary, you can apply a
small amount of CA glue to hold the
pieces permanently in place.

Step 5: Cutting the Control Surfaces
Before flying, you will need to cut the control
surface so they can move freely. Using a sharp
razor knife, cut only where indicated with
dashed lines in the above illustration.

Step 4: Receiver and Battery Installation
Using the double sided tape, install the receiver
into the fuselage and plug the servo and ESC
leads into the appropriate channels. Using the
included Velcro strip, install the battery into the
front of the fuselage.

Step 4

Step 5