HITEC Zipper - Manual (Page 4)

4
A. Fuselage Assembly (includes installed Motor,
ESC and Elevator Servo)
B. Main Wing
C. Horizontal Stabilizer
D. 2x Spinner
E. Small Parts Package, Includes:
i. Propeller
ii. 1 piece 2.0 x 16mm screw for wing
iii. 1 piece double sided tape for
mounting receiver
iv. 1 piece Velcro hook and loop for
mounting battery
ASSEMBLY INSTRUCTIONS
SECTION 2
Tools Required for Assembly
• #1 Phillips Head Screwdriver • Razor Knife
Step 1: Horizontal Stabilizer Assembly
Slide the horizontal stabilizer through the fuselage until it locks into place. Slide the elevator linkage
into the swivel and tighten the screw.
Step 1
While not necessary, you can apply a small amount of CA glue to hold the pieces permanently
in place.
PARTS LAYOUT AND LISTING
Note: Before assembly, it is important that you remove the parts from the packaging and
check to make sure that all the parts are included and that they are in good condition.