Heath Consultants ODORATOR 2 - Manual (Page 13)

9
Battery Pack Replacement
When the battery pack wears out or the need arises to replace the battery pack do so by:
1.
Turn the ODORATOR 2 “OFF”.
2. Raise the accessories door by pulling up on the knob.
3. Loosen the two thumbscrews on the battery cover.
4. Pull out, then up to remove the cover and set aside.
5. Squeeze the conne
ctor’s lock to disengage and unplug the battery from its
extension.
6. Plug in the new battery pack. The instrument will boot-up. Turn the
ODORATOR 2 “OFF”.
7. Set the new battery pack in the cover and tuck the wiring in between the pack
and cover.
8. Position the two lower tabs into their slots, position the cover into place and
tighten the thumb screws finger tight.
9. Recharge the new battery pack prior to use