Hase Lisboa - Manual (Page 32)

32
unless absolutely necessary. Make sure the
room is well-ventilated and open the windows
and outside doors. If needed, use a fan for
faster air circulation.
If the maximum temperature is not reached during the first
heating operation, you may notice an odour for a short period
of time the next time the stove is used as well.
7. Lighting the Fire
The firing up phase should be as short as possible, since high-
er emissions can occur during this phase.
The slider settings described in Table 1 (see figure on the right)
are recommendations that were determined under confor-
mance testing conditions, in compliance with the relevant
standard. Depending on the weather conditions and the drau-
ght capability of your chimney, accordingly adjust the slider
positions for your Lisboa to the local conditions.
CAUTION!
The Lisboa may only be operated when the fire
box door is closed; the fire box door may
only be opened to add fuel.
WARNING!
Never use spirits, petrol, or other flammable
fluids to light the stove.
Lighting the Fire
Procedure Position of Control
Elements
Completely open primary
and secondary air.
Pull primary and secondary
air slider all the way to the left.
(fig. 6)
Open fire grate. Pull out fire grate slider.
Pile up any remaining ash
and unburned Charcoal
into the centre of the
combustion chamber.
Place 2-3 small logs into
the middle of the fire box;
stack approx. 0.5 kg of dry
wood chips on top.
Light the ignition material
at several places.
Tab. 1
(I) (II)
fig. 6
8. Adding Fuel / Heating at Nominal Thermal Output
More fuel should be added to the fire when the flames from
the previous burning off phase have just gone out.
Adding Fuel / Heating at Nominal Output
Procedure Position of
Control Elements
Adjust primary and
secondary air.
Set primary air slider all
the way to the right. Set
secondary air slider between
position 2 and 3 (fig. 7)
Close fire grate. Push in fire grate slider.
Add two logs weighing approx.
1,3 kg in total. Place logs with
one end to the front of fire box.
Only add a single layer of fuel.
Tab. 2
fig. 7