Dual XDVD8183N - Manual (Page 67)

XDVD8183N OPERATION
66
Troubleshooting
General
Problem Cause Action
Unit will not turn on
(no power)
Yellow wire not connected or incorrect voltage
Red wire not connected or incorrect voltage Check connections for proper voltage (11~16VDC)
Black wire not connected Check connection to ground
Fuse blown Replace fuse
Unit has power
(but no sound)
Speaker wires not connected Check connections at speakers
One or more speaker wires touching each
other or touching chassis ground Insulate all bare speaker wires from each other and chassis
ground
Unit blows fuse Yellow or red wire touching chassis ground Check for pinched wire
Speaker wires touching chassis ground Check for pinched wire
Incorrect fuse rating Use fuse with correct rating
Unit has audio
(but no video)
Parking brake safety circuit not connected
Parking brake not applied Check connections at parking brake
Apply parking brake as described on page 33
No video display
(when in reverse)
Reverse circuit not connected
Vehicle is not in reverse Check connections at reverse lamp
Select reverse gear
DVD does not start playback Physical defect in media
Wrong region
Check media for scratches
Use discs labeled "Region 1" or "All" only.
IR remote does not work Dead battery Replace battery
Excessive skipping Unit is not mounted correctly Check mounting sleeve
Physical defect in media Check media for scratches
Bad Disc appears
on display
Focus error or disc is in upside down Press eject or RESET
Incorrect Region Code
appears on display
Region code error Use only DVDs labeled “Region 1” or “All” only.
Front panel will not
open/close
Front panel obstructed Remove the obstacle and press OPEN to resume the monitor
open/close sequence.