Desa DVF36TCR - Manual (Page 5)

www.desatech.com 112108-01C 5
DIMENSIONS
FRONT VIEW
30"
(Opening)
25"
19 7 /
8
"
(Opening)
RIGHT SIDE
1 7 /
8
"
22 5 /
8
"
41 1 /
8
"
32"(Opening) 1 7 /
8
"
39 3 /
4
"
26 3 /
8
"
3"
1"
3 1 /
2
"
22 5 /
8
"
34 3 /
4
"
3"
BACK VIEW TOP VIEW
(Left Side)
(Right Side)
(Front)
(Back)
24"
10 1 /
2
"
1 1 /
2
"ш 1 1 /
2
"ш
10 1 /
2
"
11 15 /
16
"
PRE-INSTALLATION
PREPARATION
LOCATION AND SPACE
REqUIREMENTS
Determine the safest and most efficient location
for your DESA direct-vent fireplace. Make sure
that rafters and wall studs are not in the way of the
venting system. Choose a location where the heat
output is not affected by drafts, air conditioning
ducts, windows or doors. Be aware of all restric-
tions and precautions before deciding the exact
location for your fireplace and termination cap.
When deciding the location of your fireplace,
follow these rules:
• A projection may be ideal for a new addition
on an existing finished wall. Refer to horizontal
termination configurations on page 13 or verti-
cal configurations on page 15.
• Do not connect this fireplace venting to a chim-
ney flue serving a separate solid-fuel burning
fireplace or appliance.
• Due to high temperatures, do not locate this
fireplace in high traffic areas, windy or drafty
areas or near furniture or draperies.
• Never obstruct the front opening of the appli-
ance or flow of combustion and ventilation air.
Keep control compartments accessible.
• Do not locate close to where gasoline or other
flammable liquids may be stored. The appliance
must be kept clear and free from combustible
materials.
Figure 1 - Dimensions for Left/Right Side Corner Unit
Figure 2 - Direct-Vent Fireplace
Log Set
Upper
Louver
Panel
Lower
Louver
Panel