Hall Research VS-2A-PRG - Manual (Page 6)

4
Model VS-2A-PRG
3.0 Installation
. Required Cables
The video input cables are generally HD15 (VGA) male to male
(customer furnished). The Audio inputs are 3.5 mm mini-stereo (also
customer furnished). If you are going to connect the unit to a Serial port
(such as PC’s COM) you would need a Male/Female DB9 Serial Cable.
NOTE: For EDID Programming the only cables required are for the
Monitor and the RS232 connection.
. Inputs & Outputs
The VS-2A-PRG has 2 video and audio inputs: PC 1 Input and PC 2
Input. The unit has 1 video and audio output: SW Output. There is a
local video and audio output, which is a loop-out for PC 1 Input: Local.
. Connecting the VS-2A-PRG
NOTE: For EDID Programming, ONLY CONNECT THE RS232
cable and the ‘SW OUTPUT’ Connector to the device to read/write
the EDID information. No connections should be made to the ‘PC1
Input’ and ‘PC2 Input’ connectors.
Connect your video and audio sources such as computer or notebook PC
to PC 1 Input and PC 2 Input. If the loop-out for input #1 is desired, it
can be connected to local video and audio.
Connect the display device such as a monitor (or a video projector) to the
switched video and audio outputs (SW Output).
Connect the included power supply to the VS-2A-PRG.
Select the desired mode of operation including the priority for your video
and audio output using the front panel switched buttons. If preferred, the
selection can also be done through RS-232 serial commands by
connecting a DB9 RS-232 Serial cable to your PC and the VS-2A-PRG.