Grandview LF-HMF(Horizontal Adjustable Fixed-Frame Screen) - Manual (Page 4)

3
Installation
Frame Installation
Open the packing box, check whether the components which need to be installed are complete or not according to
the Accessory Diagrammatic Sketch in the user manual, then take out all the small components carefully from the
packing box and put them at a suitable place, finally install it according to the operating method as below:
figure 1
figure 2
1.Put the fixing lug into the slots of top and bottom bars, taking the following table as reference (figure 1).
Side Frame Bar
Concave Frame Bar
2.Pull up the left bar to a suitable distance, and then attach the wheel into the groove of concave frame bar. Insert
the connecting board 1 and the connecting board 2 into Concave Frame Bar(please operate together in two sides).
Finally, fasten the corresponding screws: figure 2
left Bar
Connecting Board 2
Connecting Board 1
M4X6mmScrew
M5X8mmScrew
M3X6mm
Tapping Screw
4
figure 3
3.The installation of right bar is the same as left bar. The installation has been completed (figure 3).
figure 5 figure 6
figure 4
Screen Fabric Installation
1.Put the whole frame upside down and then unwrap the screen fabric (avoid scraping the fabric when
unwrapping) (figure 4).
2.Put the tension bars to the four slots of screen fabric (note: this is a step suggested to be completed by two
persons, one to hold the screen fabric and the other pull through the tension bar) (figure 5-7).
Installation for spring of side frame bar
Spring
Screen Fabric
Rod
Position for Frame Hanger
Installation for spring of concave frame bar
Position for
Frame Hanger
Spring Rod Screen Fabric
figure7
wheel
wheel