Grandview CB-M(Cyber Motorized) - Manual (Page 3)

2 5
Motor adjusting slot
Picture 1 Picture 2 Picture 3
2. Remote control (Please see section on Remote Control)
Grandview projection screens are controlled by a manual switch or an remote control.
1.Manual switch
a.T
b.Connect to a power source (Please make sure it is the right voltage)
c. ; it will come down slowly. When it is all the way down, it
will stop automatically.
d. ; it will go up into the meta l casing. When it is all the way up,
it will stop automatically.
e.Turn the switch to position to stop any time the screen.
ear off the glue cloth fixed on the bottom rod, ensure the bottom rod is not stuck by the casing.
Turn the switch to position to lower the screen
Turn the switch to position to retract the screen
Take out all the parts from the packaging to ensure you have all necessary components.
There are three installation measures for this product, namely wall mount, ceiling mount and ceiling hang. The
installed distance can be changeable up to your needs via adjusting the slipper block, while the ideal position is the
mounting bracket is at its nearest point to the end cap, which can reduce unnecessary vibration or noise.
Installation
1. Mount the wall/ceiling brackets using the appropriate screws for your supporting material.
2. Ensure the brackets are horizontal and near the ends of the casing. Fasten to the wall or ceiling, not both.
( Figure 1) .
Figure 1
Wood wall installation Wood ceiling installation Concrete wall installation Concrete ceiling installation
Figure 2 Figure 3 Figure 4 Figure 5
Wall and ceiling installation:
Installation Steps
a) Wood supportin g materials: Dri ll in the 5 x 40 screws through the appropriate holes in the bracket
( Figure 2-3 ).
b) Concrete supporting materials: Install the anchors and drill in the 5 x 40
( Figure 4-5).
screws into the appropriate
bracket holes.
Operation
Attention:
> Please make sure there is no dust or dirt on the fabric surface before rolling it back to the casing
> The recommened working time is less than 50 seconds. The motor will enter overheating protection
status and stop working for every continuous 4 minuters operation, user would need to wait for a
while until the motor cool down before operating again.
> There is no lube needed for the motor. Please be noticed that the appropriate setting is optimized
which requires no further adjustment, please consult the after sales team before adjusting the limits.