GoldenEar Aon Series - Manual (Page 8)

GoldenEar Technology ► Aon Series Manual
Aon Series Owner’s Manual
Setting Bass and Treble Controls on Receiver or Amplifi er
Normally we recommend that you set the “Bass” and “Treble” controls on fl at (or off, or 0 dB). Same applies
for a graphic equalizer; we recommend that you leave it fl at (or off). This will give you the most accurate and
natural sound. If you want more bass, raise your subwoofer’s “Level” control (or raise the subwoofer level on
you’re a/v receiver), keeping in mind that even a little turn of the knob can make a big difference in the sound.
The reason for this recommendation is that we have discovered what is often thought to be improper sounding
speakers is, in fact, a problem caused by the use of tone controls. When in doubt, leave them out (fl at); this almost
always results in the best possible and most natural sounding system performance.
Setting Channel Levels and Bass Management in Multi-Channel Home
Theater Systems
Multi-channel surround sound systems have bass management systems (systems which direct the bass to the
various channels) which vary from unit to unit. Many problems relating to the overall sound of the system can be
traced back to improper bass management. Also note that Multi-channel surround sound systems have a critical
channel balancing procedure for setting the level for all speakers which must be followed if the system is
to perform properly. Many problems relating to the overall sound of the system can be clearly traced back to
improper system balance.
SETTING CHANNEL LEVELS: On your receiver or A/V processor’s Speaker Level Calibration Menu, set each
speaker (channel) in the system to the same volume level. While you can get reasonable results doing
this by ear, it is best to use an inexpensive Sound Pressure (SPL) meter to get better channel to channel
balance. Some new receivers and processors have Auto Set Up functions that use a supplied microphone
to set levels automatically.
Complete Home Theater Systems
We strongly suggest that you use a GoldenEar Technology center channel and rear/surround speakers, and a
ForceField ™ subwoofer, to complete your GoldenEar home theater system. Aon speakers are designed to be used
as rear or side surround speakers as well, with exceptional results for both music and movies. Of particular note, the
GoldenEar ForceField
Subs have been designed specifi cally to make a perfect match with the Aon speakers.
Mounting Instructions
Your new GoldenEar Aon speakers are designed for Bookshelf, Table Top, Floor Stand, or Wall mounting. Rubber
bumpers have been attached to the bottom of the speaker to prevent rattling and “walking” at high volumes.
Wall Mounting Instructions
If you are not comfortable performing the following mounting procedures we strongly suggest having a
professional wall mount your speakers (see your Dealer). Please note that hardware for the wall is not included —
make sure to use hardware appropriate for your wall type and the weight of the speaker being mounted.
8