GoldenEar Triton Seven - Manual (Page 3)

GoldenEar Technology ► Triton Seven Manual
3
Assembly Instructions
Parts included: Four threaded rubber feet;
Four optional spikes;
Four locking nuts.
Instructions:
1. Install leveling feet or spikes (see “Using Optional Spikes” section, below):
a. On a soft elevated fl at surface, such as a tabletop with a towel, carefully lay the Triton on its side
with the base of the tower overhanging the edge of the table.
b. First, install a locking nut onto each foot and then screw each foot into the four threaded inserts
on the bottom of the base.
c. Carefully return the speaker to the upright position with the help of another person — lift the speaker
upright and lower it to the desired location; if using spikes, push down on the top of the speaker to
force the spikes through the carpet and make contact with the fl oor beneath.
d. Once you have positioned the speakers, wiggle them to see if they are stable and level. Adjust
the height of the leveling feet/spikes accordingly for best level and stability, and then tighten the
locking nut.
Using the Optional Spikes
In addition to the rubber feet, optional spikes have been included should you desire to use them. The use
of these spikes will provide much greater stability when placing your loudspeakers on carpeting. It will also,
according to many experts, result in an overall improvement in sonic performance.
NOTE: Using spikes on wooden or other fl oors which are susceptible to being scratched can cause damage
to
the fl oor. GoldenEar Technology is specifi cally not responsible for damage which may result from the use
of spikes.