GoDEX Ethernet Control Center - Manual (Page 15)

Software Operation Manual 13
10. Click Submit to save your settings. And the server will reboot.
11. You have now finished the procedure of setting the wireless parameters.
＊ In infrastructure mode, Network Printer Server Control Center searches all channels to join the matched
wireless service set. In ad-hoc mode, Network Printer Server Control Center searches all channels to
join the matched wireless ad-hoc service set too, however, if none are found, Network Printer Server
Control Center creates that service set in the assigned channel.
＊ In ad-hoc mode, WPA-PSK/WPA2-PSK is not allowed.
After properly configuring the wireless parameters, you can remove the network cable and reboot the printer.
The Wireless LAN module will then connect to your wireless network. Network Printer Server Control Center
will detect if a network cable is plugged-in or not. If a network cable is plugged-in, Network Printer Server
Control Center will always connect to the network through the network cable. Otherwise it will always
connect to the network through wireless module. Once Network Printer Server connects to the network,
either by network cable or by wireless module, all operations of print server are exactly the same.