Glow-worm Ultracom hxi - Manual (Page 15)

0020127403 - 01/11 - Glow-worm
HOW TO USE YOUR APPLIANCE
- 15 -
8.5 Setting the inbuilt programmer
To alter the times to suit your
requirements, follow "Steps" 1 to 4.
MODE
PROG
Flashing cursor.
Press + or - to move the flashing
cursor to the desired time.
Press "+" to add a time segment
or "-" to remove a time segment.
STEP 1 STEP 2
"Running Time"
Indicated by solid squares.
Square represents 30 minutes.
STEP 3
Press the "PROG" button once to view Mondays
factory default central heating running times.
STEP 4 - COPY FUNCTION.
When validating the timed
intervals you can hold the
"PROG" button for 5 seconds
and the times will be duplicated
onto the next day, hold the button
continually and the times will be
copied to all days.
Press "PROG" to validate the time intervals.
The days will automatically change, repeat the process or refer to
the "Copy Function".
After the 7th. day the "Domestic Hot Water" time intervals will be
displayed, follow the same process steps 1 to 4.
STEP 4
Press "PROG" to validate the time intervals.
The days will automatically change, repeat the process
or refer to the "Copy Function".
After the 7th. day the process will exit to show the
boiler status.
STEP 4
The inbuilt programmer for
Central Heating and Domestic
Hot Water, can only be used
if Glow-worm controls are
installed.
Timed Central Heating
Factory preset timed intervals are:-
Monday to Friday - ON 6.00 - OFF 8.00.
ON 16.00 - OFF 23.00.
Saturday & Sunday - ON 8.00 OFF 23.00.
Timed Domestic Hot Water
Factory preset times for preheat are:-
Monday to Sunday - ON 6.00 - OFF 24.00.