beautypg.com

Dodge 2009 Ram Chassis Cab User Manual

Page 324

background image

CAUTION!

Use a back and forth motion to remove the hub

cap. Do not use a twisting motion when removing
the hub cap, damage to the hub cap; finish may
occur.

The rear hub caps on the dual rear wheel has two

pry off notches. Make sure that the hook of the
jack handle driver is located squarely in the cap
notch before attempting to pull off.

You must use the flat end of the lug wrench to pry off the
wheel skins. Insert the flat tip completely and using a
back and forth motion, loosen the wheel skin. Repeat this
procedure around the tire until the skin pops off.

Replace the wheel skins first using a rubber mallet. When
replacing the hub caps, tilt the cap retainer over the lug

nut bolt circle and strike the high side down with a
rubber mallet. Be sure that the hub caps and wheel skins
are firmly seated around the wheel.

Dual Rear Wheels
Dual wheels are flat mounted, center piloted. The lug
nuts are a two-piece assembly. When the tires are being
rotated or replaced, clean these lug nuts and add two
drops of oil at the interface between the hex and the
washer.

322

WHAT TO DO IN EMERGENCIES